| PH | 7.0±1.0 |
| Storage Condition | 贮存时请注意密封保存，存放于干燥、通风处，常温下有效期为12个月。 |
| Physical and Chemical Properties | Chemical quality This product is a uniform white emulsion with good film-forming performance and good friction resistance. After finishing, the leather is bright, non-sticky and feels good. |
| Use | Use for leather surface modification of, with a certain degree of water resistance. |
| Caution | Non hazardous materials, not edible, avoid contact with the eyes, can be transported as general chemicals. |
1. Oil phase preparation
Add 115kg of alcohol containing nitrocellulose, 23kg of n-butyl acetate, 50kg of n-butanol, 134kg of plasticizer, 2.9kg of thymol, 0.96kg of methylbenzaldehyde, and 10kg of emulsifier to the oil phase dissolution kettle. Slowly heat to 50-60 ℃, cover and stir intermittently several times to dissolve nitrocellulose. Store for 1 day to make it a uniform solution, set aside.
2. Emulsification
Add 12.5kg of silicone oil, 67kg of ethylene glycol, 32kg of emulsifier, 277kg of distilled water, and 200kg of table salt to the emulsifying kettle, raise the temperature to 40 ℃, and slowly add the oil phase while stirring. After adding the oil phase, continue stirring for 1 hour. Discharge, filter, continue emulsifying with a colloid mill, cycle for 5 minutes, and discharge to obtain the finished product.
oil phase preparation add 115kg of nitrocellulose containing alcohol, 23kg of n-butyl acetate, 50kg of n-butanol, 134kg of plasticizer, 2.9kg of thymol, 0.96kg of methylbenzaldehyde and 10kg of emulsifier to the oil phase dissolution kettle, slowly heat to 50-60 ℃, cover, stir intermittently for several times to dissolve nitrocellulose. Store for one day to make it a uniform solution for later use.
Emulsification: 12.5kg of silicone oil, 67kg of ethylene glycol, 32kg of emulsifier, 277kg of distilled water and 200kg of salt are added to the emulsification kettle. Raise the temperature to 40 ℃, and slowly add the oil phase under stirring. After adding the oil phase, continue stirring for 1h. Feeding, filtering, emulsifying with colloid mill, circulating for 5min, discharging to obtain finished product.